Everest Refrigeration EPBNWR2-D4 59.13" Two Section Four Drawer Back Mount Sandwich Prep Table - 15 Cu. Ft.

Everest EPBNWR2-D4 drawered sandwich prep. table.

• Heavy duty stainless steel interior / exterior with rounded corners for a hazard-free workspace.
• 16 gauge, high quality stainless steel worktop, lid and hood.
• Galvanized steel bottom and rear.
• 5" thick high density polyurethane insulation.
• Four 5" swivel casters with locks on front set.

• Back mounted, self-contained and fully detachable Blizzard R290 condensing unit uses environmentally friendly, EPA-compliant R290 refrigerant with zero (0) Ozone Depletion Potential (ODP) and three (3) Global Warming Potential (GWP). Blizzard R290 is easily replaceable and requires no on-site brazing.
• Front air breathing for flexibility in installation.
• Electronically commutated (ECM) fan motors achieve rapid cooling with less energy consumption.
• Full-length air duct system ensures optimal circulation of cold air.
• Time-initiated and temperature-terminated auto defrost cycle for seamless operation.
• Large capacity, corrosion-resistant condenser and evaporator coils.
• Self-maintaining, energy-efficient condensate drain pan requires no external drains or electric heaters.
• High performance, auto-reverse condenser fan motor supports compressor ventilation and condenser coil cleaning. Refer to owner’s manual for full maintenance instructions.
• Pressure relief devices allow smooth access to cabinet interior when re-opening doors.
• Pre-wired and ready to plug, 115V/60Hz/1Ph, NEMA 5-15P.

• Heavy duty stainless steel interior / exterior.
• 5" thick high density polyurethane insulation.
• Frame heaters prevent exterior moisture build up.
• Thick gauge, stainless steel drawer frames with low-friction ball bearings.
• Self-closing door with adjustable torsion system for a positive seal.
• Snap-in magnetic door and drawer gaskets make cleaning and replacement an easy process.
• High strength, recessed door and drawer handles.

• NSF certified polycarbonate 6" deep pans (see table for size and quantity).
• ½” thick, foam insulated lid keeps top pan area cold and prevents moisture build-up.
• 12 ¼” deep cutting board is removable for ease of cleaning.

• One epoxy coated, steel wire shelf (applies to EPBNR3-D2).
• Height adjustable stainless steel clips.

• Multi-function digital controller with easy to read LED display.
• Factory preset temperature, 35°F. Temperature setting range from 33°F to 54°F.
• Audible overheat protection alarm for compressor and condenser coil.

Everest EPBNWR2-D4 Specifications